![]() Well, first look around at the landscaping in your backyard. It’s all bound to end up in your pool at some point. How Did Dirt Get There, Anyway?ĭirt, dust, sediment. My wife loves it.” Check out this user review to find out more. As customer David Lain says, “Very pleased. Look no further than the Blue Torrent MyBot Inground Robotic Cleaner, which works powerfully to keep your walls and floor sparkling clean. Keep your sanitizer working at its highest capacity by switching to a powerful automatic cleaner that works on its own. But before we remove the dirt form your pool, let’s consider how it got there in the first place. ![]() Getting dirt out of your pool the second you see it will save your sanitizer the heavy lifting, keep you from having to be on constant chemical duty, and keep your swimmers and your pool healthy. It’s much better, then, to tend to your dirt problem the right way, right away. ![]() Additionally, dirt can stain the bottom of pools if left for too long. And if you aren’t vigilant about constantly balancing, you could experience one of the negative effects of an unbalanced pool, such as an algae bloom or swimmers potentially getting sick. This increase in consumption will cause a dent in your wallet, and more labor to more frequently balance the chemicals. But because dirt is far larger than the microscopic debris that chlorine and other sanitizers are actually intended to neutralize, a patch of dirt will exhaust your sanitizer faster than you can say “hypochlorite.”ĭirty pools will require additional sanitizer and more of other chemicals, too, thanks to how depleted sanitizer ripples out to adversely affect almost every chemical in your water balancing arsenal. Your pool’s sanitizer recognizes dirt as a pollutant, and will be hard at work to sanitize it. In the case of all sanitizing systems, dirt will be a strain and deplete its ability to work at an accelerated rate. Well, it’s actually hurting your sanitizer, whether that be chlorine, a saltwater cell, or any other of the varied options for sanitizing your pool. ![]() So why not just leave dirt in your pool? It’s not harming anyone, is it? Why You Shouldn’t Leave Dirt in Your Pool Dirt and lookalike substances, you’re going down. I’ll explain why you shouldn’t leave dirt in your pool, explore where your dirt is getting in there, and cover some of the other potential invaders that can look a lot like dirt-as well as how to get each one out of your pool, and keep them gone. If you’re finding patches of dirt gathering on your pool floor, it’s time to make a move. So what about dirt? Well, that’s one kind of debris that can’t be skimmed out-but that doesn’t mean your job is done. It’s not always a pretty sight, and you’re not always in the mood, but the five-minute exercise does wonders for the health of your water. ![]() That’s why it’s recommended that you skim out your pool with a skimmer on a telescopic pole once a day to move all that gunk floating on the surface of your pool. You must refill the pool to avoid damaging the cover system and/or pool.An uncovered pool is a massive catch-all for debris of all kinds: leaves, twigs, bugs, perhaps even an unfortunate critter, and yes, lots of dirt.cover hanging 16 inches down in pool for top or flush track, cover hanging 13 inches down in the pool for under track. The minimum safe water level in your pool is 6 inches below the water level mentioned above for your type of cover track i.e.A cover system with under track (track that is mounted in the sidewall of the pool between the bottom of the deck and the top of the pool wall) generally has a 6 to 7 inch drop to water.A cover system with top track (track that is mounted on top of concrete) or flush track (track that is mounted prior to concrete being poured and ends up being flush with the top of the concrete and both have a cover that rides over a small portion of the pool deck and then drops down to the water’s surface) will have a drop to water of about 9 to 10 inches when the pool is full of water.This distance will vary dependent upon which type of track you have.To determine the water level with the cover closed you need to determine the distance between where the cover comes out of the track to where the cover rest on top of the water (pool professionals call this the drop to water).Water levels in the pool can be determined by looking at where the pool cover rest on top of water.This will prevent you from opening the cover to check the water level. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |